Filter Cartridge

Liquid filter cartridge instructions

1. Clean the filter thoroughly

2. Open the filter cartridge, remove the inside of the filter, pay attention to the above labels and plastic bags are intact

3. Open the plastic bag and check that the seal is well installed

4. Wet the "O" ring with a process liquid (eg water)

5. To plastic packaging as a protection, hold the filter near the end of the socket, the filter will be vertical pressure into the filter positioning hole, the snap-in filter to be rotating clamp

6. Remove the plastic bag, cover the plate, tighten with the nut

7. Open the filter top vent valve

8. Slightly open the inlet valve to allow the liquid to enter the filter when the liquid overflows from the exhaust valve and then closes the exhaust valve

9. Slowly open the downstream outlet valve until it is fully open

10. Slowly adjust the inlet valve until it is fully open

11. Flush for every 10 "filter with a 250L / h flow rate for 10 minutes

12. should not be large flow impact filter, to avoid the opposite direction of pressure

13. If the filter pressure △ P> 0.15Mpa or a significant decline in flow, it indicates that most of the filter hole has been blocked

14. If the filter is not used, the filter should not be dried, but the filter should be stored in the filter, the filter into the water containing antibacterial agent (such as 10ppm sodium chloride solution or 2% hydrogen peroxide solution, Before use, the antibacterial agent should be washed clean)